SCHEME roll dynamo FAN

* Connecting the wire to the ignition coil is SERI conducted (see fig scheme). For more details please click on the image scheme

simple roll tool

Roll dynamo FAN

  "THE MORE WE CAN DO THEN WILL BE MORE JOB OPPORTUNITIES THAT WE CAN". Roll dynamo fan is not as complicated to fix the tv. In terms of economy is not very profitable. But this is only the first step as an exercise roll dynamo. If we have advanced roll fan dynamo, dynamo roll such as washing machines, water pumps, generators portable, outdoor air conditioning blower even dynamo for industrial equipment does not become more difficult. If it were up to at this stage, so the results could be more promising than the tv repair. Given that the analysis of the damage is not too difficult and can predict certain dg old craftsmanship, working capital as well as how the results are. Not to mention traces of copper wire worth a hefty savings when the time requires an extra fee.

 

Kiren fan

While roll dynamo fan, if you do it manually, patience, skill and your memory properly tested so as not to err in the process of calculating and inserting a wire into the cool which can cause the dynamo does not work perfectly and durable. Understandably wire is very fine with that number quite a lot.
Here I try to share with colleagues through schematic drawings that I created and uploaded. Hopefully so it is easier to understand. Standard wire diameter and number of coils that I use is the standard dynamo that most Maspion fan on the market. May be useful. Criticisms and suggestions are my hope.

1 set spool dynamo fan

rolls who have been so

NOTE:
The number of primary windings can be added up to 10% more durable with consequences for dynamo round a little slower.
If an error occurs in the direction of rotation, can be overcome only way dg cool reverse dynamo or change the position of the connection coupling the dynamo. It's as well we know how to disconnect the wire at the base of the main roll of wire and medium speed (high speed / 1). Then move the base of the wire medium speed wire the ends of the primary windings previous reply to the capacitor and then move the cable connection to the capacitor at the base of the main roll of wire.
  Use the blade of bamboo / wood thin face who in the end to help push the wire into the hole hole cool. Do it carefully. Please note the direction of the windings for each pole.
Just to add a reference to Chinese fans that cool tbl roughly only 1-1,2Cm, which used 0.12 wire and number of turns ranging dg 0,10mm 900-1200 windings. for the roll medium / low speednya no more than 20% of the total winding example: ... a total of 1000 loops => medium = 200, low = 200, 600 starter capacitor 1-1,2uf / 400VAC. but can rarely preserved chinese fan constantly using that, due to the wire and cool in use too small / thin so it does not heat resistant.